Z bar flashing provides an inexpensive and easy to install method of stopping water penetration behind siding.
Z bar flashing installation.
Place the z flashing into position on top of the casing.
Test the rotted area of the t1 11 siding by poking it with a nail or a screwdriver.
Window and door cap 1 25 in x 120 in x 1 56 in aluminum z flashing.
The z bar is available in 018 033 043 054 thickness of steel.
Designed for roofing applications.
Galvanized steel unless specified.
Flanges are available in lengths of 1 1 1 1.
Backleg made of 28 gauge galvanized steel.
Bailey s z bars are ideal for many construction applications such as continuous framing insulation reinforcement slides track and roofing.
Galvanized steel z flashing is made from 28 gauge galvanized steel.
How to install z flashing on rotted t1 11 siding 1.
Suitable for residential or commercial use.
If only the surface is damaged.
Thd sku 686080.
Check out our recommended tools right here.
Scrape loose paint off the rotted area with a putty knife and use 80 grit sandpaper to smooth the rough surface if.
Steel z bar flashing with 2 in.
It is used to protect the horizontal joints between sheets of siding from water infiltration.
Flush the end of the flashing length with the wall corner and secure the flashing to the framing with an 8d nail at each wall stud.
Begin at either end of the wall and set the level middle section of the z flashing onto the top edge of the siding panel with the wider flange upward and against the wall framing.
Z bar design easily accommodates rigid insulation.
Install the first length of z flashing.
The seat dimension 3 8 in corresponds to the siding thickness.
When installing the flashing the longer edge goes against the wall of the house the center section rests on top of the casing and the.
